Savin 4027 Servisní příručka stáhnout pdf (Strana 155)

11. Remove the scanner motor belt [A] by

removing the pulley [B] (1 Allen screw).

12. Remove both bearings [C] (1 E-ring each).

13. Remove the left cover and swing the main switch bracket [D] out of the way.

14. Slide the front pulley to the cutout [E] of the front frame and remove all four

scanner drive belts.

When reinstalling, make sure of the following points:

If the pulleys [F] have been removed, make sure that they face the

same direction as shown when you put them back.

The belt tension bracket should be tightened after all the belt tension

springs have been installed.

Adjust the position of the 1st and 2nd scanner by using the positioning

bracket kit. (See Scanner Positioning Adjustment.)

A156/A160/A162 5-8 FSM

CÓPIA NÃO CONTROLADA

Žádné komentáře

Savin 4027 Servisní příručka Strana 155