Savin 2513f Provozní pokyny stáhnout pdf (Strana 67)

NetWare 4.x, 5 - Advanced Settings

Setting Up as a Print Server

Important

❒ You can set up the print server using the NDS or Bindery mode in NetWare

4.x, 5. The following procedure is for setting up the print server using the

NDS mode in NetWare 4.1. When you set up the print server using the Bind-

ery mode, use the NIB Setup Tool Wizard. ⇒ P.43 “Quick Setup Using the NIB

Setup Tool Wizard”.

Note

❒ If you use Pure IP in NetWare 5, follow the procedure on P.55 “Using Pure IP

in the NetWare 5 environment”.

Log on to the file server as an Admin or an Admin equivalent.

Run the NIB Setup Tool.

Reference

⇒ P.42 “Running the NIB Setup Tool”

Click [Property Sheet] and click [OK].

Click [IPX protocol].

Click the IPX address of the Network Interface Board which is to be config-

ured, and click [Next >].

Note

❒ If you do not know which Network Interface Board you are configuring,

see the network configuration page to check the MAC address (Network

Address).

Make sure that the MAC address and IPX address are correct, and click [Fin-

ish].

The [NIB Setup Tool] window appears.

Click [Configure].

The property sheet appears.

Click the [General] tab, and type the name of the print server into the [Device

Name] box.

Click the [NetWare] tab, and make the following settings.

A In the [Print Sever Name:] box, type the name of the print sever.

B In the [File Sever Name:] box, type the name of the file sever in which a

print server is to be created.

Clicking [Browse], you can select a file server among those listed in the

[Browse] dialog box.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 111 112

Žádné komentáře

Savin 2513f Provozní pokyny Strana 67